3 replies to this topic

[Mh-m11a1]

Ok, so i have recently found out that my hop up bucking is swollen with silicon oil.
Need help on how to take it out correctly. KWA support would tell me hot to take it appart because its "part of thier policy" and redirected me here.

Anyway, I have it mostly disassembled down to the barrel section (first picture), and the hop up bucking is in their pretty good.

The inner barrel clip, i cannot get out/off of the assembly.the only thing that seems to move is the bb feed ramp that folds down (second picture)

Any ideas on how to take out the hop up bucking properly would be greatly appreciated.

 Resampled_1.jpg   41.3K   35 downloads

 Resampled_324.jpg   27.7K   35 downloads

Edited by Mh-m11a1, 12 March 2012 - 02:45 PM.

[Desert Punk]

Remove part number 22. http://kwausa.com/fi...01V01_M11A1.jpg

[Mh-m11a1]

part 22 has no pin sustaining it in place, but it is glued on. (thats the way it came)
ive tried getting that off before, any other ideas ?

[Desert Punk]

Heat it up with a heat gun or hot water to melt the glue.