3
Tools Require:
* Valve Key (available to purchase from airsoft retailers)
* 2.0 mm Allen Wrench
*** DO NOT OVER TIGHTEN THE VALVE, over tighten can damage the tread and will affect the gas release when operating in hot temperature ***
Step 1
Remove two screws on to of the mag.
Step 2
Carefully removing the magazine feed lip, tiny parts WILL fly out!!
Step 3
Locate the Release valve in the mag, Insert valve key and turn Clock-wise to tighten.
Step 4
Insert the Release Valve Block in the Magazine. Make sure the open slot is vertical so the long screw can be insert into the mag later.
Step 5
Place the Magazine disconnector and disconnect transfer onto the magazine.
Step 6
Insert the BB follower spring and BB follower into the mag.
Step 7
Hold down the follower on the side and the Release Valve block in the rear. Carefully put the Magazine Feed Lip back on.
